Cleaning Your Wood Product
Make sure the wood surface is dry. With A dry, lint free rag, spray the cleaning solution onto the wood surface as needed and wipe off excess cleaning solution. Please allow 20-30 minutes to fully dry before regular use. The spray not only acts as a cleaner but it also acts as a maintainer for your finish leaving you with a refreshed look as it has top oil integrated within the spray.
Repairing Surface Scratches
In the event you need to repair a surface scratch, you're in luck! Our hardwax finish allows for spot repairs!
Simply do the following:
- Scuff the area you're trying to repair with a scotchbright pad
- Apply a small amount of oilwax to a clean rag
- Simply wipe on the finish in the area you're trying to repair
- Allow finish to set for a few minutes
- Wipe off any extra finish to prevent an uneven look
- For best results, we recommend applying several coats as needed
- You can also try applying the finish to the entire damaged panel (Drawer front, door, side, etc.) which can create the most uniform look
Removing Door
Press the rear release lever and pull the back of the hinge forward to pop the hinge off the base plate.
Attaching Door
Line up the front hooks of the hinge to the metal dowels on the front of the mounting plate. Press firmly on the back of the hinge to snap it in place.
Removing Drawer
Pull the left and right release levers on each drawer clip and pull the whole drawer forward.
Inserting Drawer
Line up the drawer box on the two drawer slide rails. Pull each slide rail forward until you hear it click into the drawer clips. Do that for both left and right slide rails.
Adjusting Drawer Up And Down
Turn The Adjustment wheel to the right to move the drawer front up. Turn the adjustment wheel left to move the drawer front down.
Adjusting Drawer Left and Right
Turn the adjustment wheel to the right to move the drawer front right. Repeat on the alternate side for the best adjustment. Repeat as needed for the best alignment.
Adjusting Door Left and Right
Using A phillips screw driver, turn the front adjustment screw to move the door left or right.
Adjusting Door Up And Down
Using A phillips screw driver, turn the center adjustment screw to move the door up or down.
Adjusting Door In And Out
Using A phillips screw driver, turn the rear adjustment screw to move the door in or out.
Adjusting Door Stops
Using A phillips screw driver, loosen the screw and turn the door stop clockwise or counterclockwise until door flushes out the the desired position. Tighten the screw to fix the stop in place.
